|
Title: Header question Post by: Lancia76 on November 07, 2015, 12:54:28 AM Hi guys
Need some advise on a set of ANSA headers. I have a 1976 beta 2 litre carbed and have found a Set of ANSA headers that are 4-2-1 but they are off a 1800. Will this 1800 header still Fit my 2000? Regards Title: Re: Header question Post by: lbcoupe76 on November 07, 2015, 03:17:25 AM They will bolt on, though i'm not sure about clearance where they curve under the car as the 2lt block is taller.
Title: Re: Header question Post by: Lancia76 on November 07, 2015, 11:18:53 AM Thanks bud your correct just measured a 1800 and it's around 10mm shorter.
Few mods I guess. Title: Re: Header question Post by: HFStuart on November 08, 2015, 07:52:18 PM They will just clear the crossmember and sway bay. You'll need to heatwrap the header or you will cook the rubber boots on the steering rack.
Also be aware the bolt pattern and positioning of the ports on the heads differs. If you put a 1600 header (with I think this one will be) on a 2 litre it may mask the exhaust ports - its not big deal you can just redrill the holes 1/4" or so offset but best to check first. Use the old exhaust manifold gasket as a guide. Title: Re: Header question Post by: lbcoupe76 on November 09, 2015, 01:55:17 AM Hi Stuart, we never got the 1600 in Australia. Started as 1800 and then 2000.
Title: Re: Header question Post by: Lancia76 on November 09, 2015, 02:31:58 AM Hi
The headers are from the states. So they might be off a1600. I decided not to buy them as the price was too much. I can get them made here in Oz. Thanks guys |